CODE 874110/ACO - Timer box without correction - ACOVA : 874110

Not contractual photo

Timer box without correction  - ACOVA : 874110 Maximize

Replaces the old ACOVA codes: BTIMER1-S ,BTIMER2-S and 874100

More details

874110/ACO

Out-of-stock

Old ACOVA codes: BTIMER1-S ,BTIMER2-S and 874100
The 874110 unit to replace the Cadir and X3D models
To change reference 874100 or 874130, replace your defective programming unit with this one.
You can also use it as replacement for the Cadir 894250 regulation + printed circuit 874140 or the receiver X3D 895580 + thermostat 895570.
Replacing the Cadir

Remove the receiver cover
Remove the infrared printed circuit board protective cover
Unscrew the wiring to remove the electric radiator head
Open the new unit to access the electrical board, Using a 10 Torx key
Place the 874110 unit onto the towel dryer and then wire it, with 2 10 cm long wires
Place the connection terminals on the resistor
Adjust the length of the wires to make the junction
Close the unit, hiding the wires inside it
Test the installation after putting the towel dryer cover back into place

Replacing the X3D

Remove the receiver cover
Remove the infrared printed circuit board protective cover
Unscrew the wiring to remove the electric radiator head
Connect the resistance with a Wago or insulating screw joint
Put the protection back into place
Install the X3D RF receiver box using a two-sided (not supplied)
Electrically connect the X3D receiver to the power supply, taking account of the following characteristics

3-wire cable: receiver
2-wire cable: resistance



Why choose the ACOVA unit towel dryer TIMER PROG type?
The TIMER PROG electric towel dryer unit made by ACOVA works on an electric towel dryer (also called an electric towel warmer) or on an electric radiator. In addition to containing a calibration ring and temperature control knob, a 2 hour forced power on button enables you to enjoy the comfort of the electric towel dryer. After several hours of operation, turn the temperature knob to increase or decrease the temperature in the room of the house (usually the bathroom).
The characteristics of the complete towel warmer unit:
There are the following controls on the ACOVA towel-dryer unit:

Heating on/off button
Power on indicator light (indicating light type)
Forced power on button for 2 hours TIMER PROG
Operation light indicator (indicating light type)
Calibration ring
Temperature control knob
Adjustment mark


How to adjust the Acova towel dryer?
As with all other towel warmers (SAUTER, THERMOR, LEROY MERLIN or CASTORAMA towel dryer), an ACOVA towel dryer must be electrically connected and in operation (heating on off button). You then have to adjust the ACOVA towel dryer thermostat by turning the heating knob. The temperature increases, you can then reduce the temperature after you have determined the right temperature in the bathroom. If you want to change the temperature of the towel dryer several hours later, turn the temperature knob on the ACOVA control unit. In case of a malfunction, refer to the ACOVA towel dryer leaflet that could lead you to perform a connection test or replacement of spare parts. Additional information: this product is sold in the boiler manufacturer's packaging, it has not been modified in any way.





Additional information:
This part is sold under boiler manufacturer packaging, without any modification.
Accept

We use cookies to provide a better experience. Carry on browsing if you're happy with this, or click here to manage cookies.